SDK
- How to Check and Toggle your GoEmulator or Sensor Replay State
- Compilation error due to incorrect referencing in C# and VB.Net
- Warning about GoSensor_EnableData()/GoSystem_EnableData() Usage
- Limitations to Using GoSystem_AddSensor()
- Size of dataQueue
- Integrating the SDK within a .NET application (C#, VB.NET, etc.)
- Reading profiles in C (Gocator firmware 3.x)
- Minimum version of VC++ for SDK
- Measurement data not received in the SDK even though measurements are added
- Combining data when using a multi-sensor setup (G2xxx)
- No data output when using Gocator SDK examples
- Examples on how to use the Gocator SDK (Gocator firmware 3.x)
- No SDK command to reset encoder count
- Gocator SDK 64-bit Windows support
- Saving the current Gocator configuration through the SDK
- Activating or switching jobs via SDK (Gocator 4.x)
- Gocator encoder index and encoder index pulse (Z)
- Gocator encoder Z signal needed for encoder triggered operation
- Checking if Buddy is assigned through SDK (Gocator firmware 3.x)
- Return value of Go2System_SensorCount
- Multiple sensors (Gocator firmware 3.x)
- Knowing number of data points before receiving first profile data