Question
Why do I only see one part when I scanned more than one part when in the web interface?
Answer
| Sensor Model | G2xxx |
| Firmware Version | 3.x, 4.x |
| SDK Version | n/a |
When Gap Length / Gap Width (in the Part Detection panel on the Scan page in Gocator 4.x) or Gap Threshold (in the Detection panel on the Setup page in Gocator 3.x) is set correctly, all parts are scanned, but only the last one is displayed.
Use the record tool (see Recording, Playback, and Measurement Simulation in the user manual) while scanning to show all parts in replay mode.
Comments
0 comments
Please sign in to leave a comment.