How to load a .user file from another person into the Gocator Surface Track tool

During the design process for a glue bead or weld inspection application, you may find yourself needing some assistance with the configuration of the Surface Track tool parameters. This can be a bit tricky since you will need to share a .user file with tech support, they will send a modified .user file back to you, and you will have to load the .user file onto an active sensor. This procedure shows you how to load a .user file from another user (like LMI Tech Support) onto your sensor. 

1. On sensor, load the .job that includes your Surface Track tool and make it the active/current job
2. On sensor, upload and merge whatever .rec file you wish to use with the Surface Track tool or take a new scan (as long as it is the same as the .user file was originally generated from)
3. On sensor, enter Replay mode
4. On PC, launch the TrackEditor utility available in the GoUtilities package from the LMI Support site. The version of the TrackEditor must match that of the sensor itself
5. In the Track Editor, select PC as the file source location
6. In the Track Editor, press Load Tracks and find the .user file provided by the other user (i.e. LMI Tech Support)
   1. For FW versions 5.3 SR1 and newer, you should copy the modified .user file to this folder with a unique name: C:\GoTools\SurfaceTrack 
   2. For FW versions 5.3 and older, you should copy the modified .user file to both of these folders with a unique name: C:\LMI\SurfaceTrack  AND C:\LMI\SurfaceTrackSensor. The SurfaceTrack folder will be used with your Emulator and the SurfaceTrackSensor folder will be used with your sensor
   3. For GoPxL you should copy the modified .user file to the folder of your GoPxL Utilities with a unique name:  GoPxL_Utilities\Tools\TrackEditor\TmpDirGpws\gdk\SurfaceTrack
7. In the Track Editor, press Open
8. In the Track Editor, change your Source to Sensor
9. In the Track Editor, type in the IP address of the sensor you wish to store the .user file on
10. In the Track Editor, press Connect
11. Once connected, click Save Tracks As and give it a new name for storage on the sensor. Click Save. 
12. On sensor, go to the Measure page and select the Surface Track tool
13. From the Operation dropdown of the Surface Track tool, select Refresh File List
14. From the File dropdown of the Surface Track tool, select the file you just saved on the sensor
15. From the Operation dropdown of the Surface Track tool, select Load. This should load the new track, and you should see the calipers on your stored image.
16. Save the loaded job to retain these settings on sensor