Discovering the GoMax NX or GoMax IP address using Wireshark - not visible on kDiscovery

What does one do when they cannot connect to a GoMax device when the default IP address of 192.168.1.6 fails? Is it possible to use the kDiscovery application for the former mentioned?

GoMax IP address will not be visible on the kDiscovery interface. You will have to use a third party network traffic monitoring software such as Wireshark, or IPscan to find out the IP address if it isn't 192.168.1.6 (Eth 1 Port) (or 192.168.2.6 if you connect to the Eth2 port - Hardware Overview)

Ensure that the connected ethernet adapter is on the 192.168.1.x network.
 
The IP address was likely changed by someone -Once you open Wireshark , click on the Ethernet adapter that is connected to the GoMax and sensor network. Enter a UDP filter and then look for an IP address that isn't a sensor.

See snippet below showing sensor on 192.168.1.11 and GoMax on 192.168.1.6 on wireshark and also, kDiscovery only showing the sensor.

kDiscovery is available with the Emulator & Utilities package - https://lmi3d.com/product-downloads/

For any further support, please reach out to support@lmi3d.com