Main Menu

All times are in GMT -8 (DST) :: The time is now 1:39 pm.

Login or Register
Create an account and register your LMI products to gain access to useful resources.

Register Account

Login

Sub Menu

Knowledge Base
Article Data
Article Ref
1379-IFGJ-0059
Date Created
Fri, 28th Feb 2014
Date Modified
Fri, 4th Jul 2014

   Only one part showing in web interface even though multiple parts were scanned (G2xxx)

Question 

Why do I only see one part when I scanned more than one part when in the web interface?

Answer 

Sensor Model G2xxx
Firmware Version 3.x, 4.x
SDK Version n/a

When Gap Length / Gap Width (in the Part Detection panel on the Scan page in Gocator 4.x) or Gap Threshold (in the Detection panel on the Setup page in Gocator 3.x) is set correctly, all parts are scanned, but only the last one is displayed.

Use the record tool (see Recording, Playback, and Measurement Simulation in the user manual) while scanning to show all parts in replay mode.