Main Menu

All times are in GMT -8 (DST) :: The time is now 2:42 pm.

Login or Register
Create an account and register your LMI products to gain access to useful resources.

Register Account

Login

Sub Menu

Knowledge Base
Article Data
Article Ref
9627-OHZV-8037
Date Created
Fri, 12th Jun 2015
Date Modified
Fri, 12th Jun 2015

   Shift in color texture in scans

Question 

Why is there a shift in color texture in my scans?

Answer 

Some sensors require color offset modification due to hardware changes from the manufacturer.

When the mesh and the color texture don't match, go into the Device tab. You will see an advanced variable called "TextureShiftY". Change the value so that it is between -32 and +32 to adjust the texture position. (You can increase by increments of eight, which makes it easier to figure out the correct position.)

This value could be different for each device, so make sure to double-check on each sensor.